Combining rail for the long haul with trucks for the first and last mile can lower both freight cost and emissions, without giving up door-to-door service.

Long-distance trucking is flexible, but it is also exposed to driver shortages, road tolls, fuel prices and growing pressure to cut emissions. Intermodal transport keeps the truck where it adds the most value, at the start and end of the journey, and hands the long middle section to rail. For the right flows, the savings are significant.

How intermodal transport works

Goods are loaded once into a container, swap body or trailer at the shipper’s site. A truck takes the unit to a nearby rail terminal, a train carries it across the country or the continent, and another truck delivers it to the final address. The cargo itself is never handled between modes, which reduces damage and theft.

The emissions case

A single freight train can replace dozens of trucks on a long inland route. Industry estimates put the reduction in CO₂ per tonne-kilometre at up to 70 percent compared with road-only transport, depending on the energy mix used by the railway. For companies with climate targets, that is one of the largest single levers available.

Truck collecting a container for the first mile of an intermodal trip
Trucks handle the short first and last legs, while rail takes the long haul in between.

We report emissions per shipment, so you can track the impact of each move in your sustainability reporting rather than relying on rough annual estimates.

When intermodal makes sense

Intermodal is not the answer for every load. It works best on distances above about 500 km, with regular weekly volumes and rail terminals reasonably close to both pickup and delivery points. Very urgent or irregular shipments usually stay on the road. Heavy, dense cargo such as beverages, paper, metals and building materials tends to benefit most, because rail handles weight efficiently and the savings grow with every extra tonne on the main leg.

FactorRoad onlyIntermodal
Typical distanceUnder 500 km500 km and above
CO₂ per tonne-kmBaselineUp to 70% lower
Transit timeFastestOften +1 day
Cost on long lanesHigherTypically 10–25% lower
FlexibilityVery highFixed departures

Getting started

The best way in is a pilot on one or two steady lanes. We look at your shipment history, identify flows that match the profile and run them side by side with your current road service. Our road freight team handles the first and last mile, so you keep one contact for the whole journey. After a few months of data, the decision to scale up is usually easy to make.

  • Steady volumes: Regular weekly loads make it easier to secure fixed train slots.
  • Flexible delivery windows: A half-day window absorbs small variations in train arrival.
  • Heavier loads: Rail often allows higher gross weights than road on the main leg.
  • Clear reporting: Shipment-level emissions data supports your sustainability targets.

“Intermodal is one of the few changes that saves money and emissions at the same time. The trick is choosing lanes where the volumes and terminals line up.”

Tom Becker, Head of Trade Compliance at Cargo

Key takeaways

  • Intermodal pairs rail for the long haul with trucks for short first and last legs.
  • It suits lanes above roughly 500 km with steady weekly volumes.
  • CO₂ per tonne-kilometre can fall by up to 70 percent compared with road only.

Curious which of your lanes could move to intermodal? Request a quote and we will run the comparison for you.